Oak Heat Grilles & Wood Registers
We will try to make purchasing wood floor vents, heat grilles, oak vents, grates or wood registers easy.
A "Register" is basically a grille with a damper attached to control air flow from a forced air or heat system. Usually the actual metal register is mounted in the sub floor and covered by sometimes decorative vents, but we can order any stock size wood grille with an attached metal damper. Original wide louver wood vents and baseboard vents do not have the attached damper as an option.
Most manufacturers make their wood registers & wood vents quite different and here is how.
Some grilles are made out of a flat wood board (oak, maple, whatever species) and the louvers are either cut, drilled, or routered out of this single piece. Mostly strait cuts but some do angle the louvers. You should finish these very well to prevent warping splitting & checking.
Another way is a grille or grate that is not 1 piece of wood. These vents are also well made but different in that the frame is 4 pieces and all the louvers are individually hand assembled and glued. This style may reflect a slight cost difference as you shop.
And of course for all those of you where everything in your house seems to be "custom", we do that too. Any wood grill, grate or vent can be made to your specifications.
All our wood vents are shipped sanded and cleaned; ready for on-site finishing
We also offer a factory finish any wood grain. A sample must be submitted so we can match it perfectly.
We matched the vents above to our customer's sample.
Choose a link below to see specifications and sizes. Can be made custom
to any heating duct opening.
Copper Finials |
Oak Grilles Vents & Registers
Copper Roof Vents & Flashings
Gutter Accessories |
Underground Garbage Cans